The Model Railway
Software
trainctrl
Set Cmds
Get Cmds
Read Cmds
Route Cmds
Misc Cmds
Wildcards

Read Commands

"read velocity meters" : RC-> r [<block>]+

Evaluate the velocity meters of the specified block sections. At least one block section must be specified by its label. To simplify typing commands capital letters may be replaced by small letters and underscores may be omitted.

"trace velocity meters" : RC-> t [<block>]*

Start tracing the velocity meters of the specified block sections. Each time a train passes one of the selected velocity meters, the measured value is displayed immediately. The set of selected velocity meters may be changed by issuing further trace commands. Specifiying an empty set terminates the trace. At least one block section must be specified by its label. To simplify typing commands capital letters may be replaced by small letters and underscores may be omitted.