trainctrl

General Usage

The binary of the trainctrl application program may be found at "/home/railway/bin/trainctrl". In order to run trainctrl properly, you must be logged in to the console of gershwin, which is the work station directly connected to the model railway. The program is started without any parameters. On successful startup, the prompt RC-> is displayed and the program waits for user commands.

Command Survey

set commands get commands read commands route commands misc commands

ssp "set speed" gsp "get speed" r "read vm" grt "get route" c "clear"

sdi "set direction" gdi "get direction" t "trace vm" srt "set route" h "help"

spt "set point" gpt "get point" drt "drive route" q "quit"

ssi "set signal" gsi "get signal" crt "clear route" e "quit"

sre "set relay" gre "get relay" trt "trace route" x "quit"

sst "set state" gdi "get state"

Clemens Grelck
generated on: Tue Jul 13 13:31:30 MET DST 1999